1094A

1094A

Back to Main Genelec Page

Pricing Sheet

Driver
The 1094A has one 385 mm (15") cone driver, capable of producing very high SPLs. The driver is housed in a 110 liters vented cabinet. The driver is front loaded to improve both the passband efficiency and stopband rejection.

Amplifier
The amplifier produces 400 W of short term RMS power, with very low THD and IM distortion. It is mounted on a large, thick aluminium plate with excellent heat dissipation. Overload protection and power-on muting are included in the amplifier circuitry. The amplifier also incorporates thermal overload and short circuit protection.

Frequency response: 29-80 Hz (+/- 2.5 dB)
120 dB SPL short term @ 1m half space, average over 35-85 Hz
385 mm (15") drivers
External dimensions 739 x 468 x 620 mm (29 x 18 3/8 x 24 4/8 inches)
Amplifier 400 W
Electronic crossover and protection circuitry
Built in crossover filter, subsonic filter
Bass roll-off, phase matching controls

Retail $5,499 CAD (Each)

Our Price $3,169 US (Each)

Our Price $4,875 CAD (Each)

Order Form

System Specifications

Free field frequency response of system (± 2.5 dB):	29 - 80 Hz
Maximum short term sine wave acoustic output in half space, averaged from 35 Hz to 85 Hz @ 1m:	> 120 dB SPL
Self generated noise level in free field @ 1m on axis (A-weighted)	< 10 dB
Harmonic distortion at 100 dB SPL @ 1m on axis in half space (30...100 Hz):	< 3%
Drivers:	385 mm (15")
Weight:	50 kg (110 lb)
Dimensions: Height Width Depth	739 mm (29") 468 mm (18 3/8") 620 mm (24 4/8")

Amplifier

Short term amplifier output power:	400 W (8 Ohm)
Long term output power is limited by driver unit protection circuitry.
Amplifier system distortion at nominal output:	THD < 0.08% SMPTE-IM < 0.08% CCIF-IM < 0.08% DIM 100 < 0.08%
Signal to Noise ratio, referred to full output:	> 100 dB
Mains voltage:	100/200 or 115/230V
Voltage operating range:	± 10%
Power consumption (average): Idle Full output	60 VA 650 VA

Crossover

Subsonic filter (18 dB/octave) below:	29 Hz
Crossover frequency, (sub/main monitors)	85 Hz
Crossover acoustical slope Lowpass: Highpass:	28 dB/octave 12 dB/octave
Midband rejection, freq. > 400 Hz:	> 50 dB
Bass roll-off control operating range in 2 dB steps:	from 0 to -6 dB @ 33 Hz
Phase matching control in 90° steps:	from 0° to -270° @ 85 Hz

Input/Outputs

Input connectors: XLR female	pin 1 gnd pin 2 + pin 3 -
Input impedance:	10 kOhm balanced
Input level for 100 dB SPL output @ 1m:	variable from +6 to - 6 dBu

Output connectors: XLR male	pin 1 gnd pin 2 + pin 3 -
Output impedance:	100 Ohm balanced, active floating
Gain:	0 dB