1092A

1092A

Back to Main Genelec Page

Pricing Sheet

Drivers
The 1092A uses two 210mm (8") cone drivers with large magnets and displacement capability. The drivers are housed in a 55 liters vented cabinet and they are front loaded to improve passband efficiency and to improve the stopband rejection.

Amplifier
The amplifier produces 180 W of short term RMS power, with very low THD and IM distortions. The amplifier includes circuitry for driver overload and thermal overload protection ensuring the long term reliability of the drivers. The unit also contains a muting circuit disconnecting the amplifier and filter outputs when the mains power is switched on and off to prevent pops and clicks.

Frequency response: 33-80 Hz (+/- 2.5 dB)
115 dB SPL short term @ 1m half space, average over 35-85 Hz
2 x 210 mm (2 x 8") drivers
External dimensions 615 x 320 x 510 mm (24 1/6 x 12 1/2 x 20 inches)
Amplifier 180 W
Electronic crossover and protection circuitry
Built in crossover filter, subsonic filter
Bass roll-off, phase matching controls

Retail $3,299 CAD (Each)

Our Price $1,828 US (Each)

Our Price $2,813 CAD (Each)

Order Form

System Specifications

Free field frequency response of system (± 2.5 dB):	33 - 80 Hz
Maximum short term sine wave acoustic output in half space, averaged from 35 Hz to 85 Hz @ 1m:	> 115 dB SPL
Self generated noise level in free field @ 1m on axis (A-weighted)	< 10 dB
Harmonic distortion at 100 dB SPL @ 1m on axis in half space (30...100 Hz):	< 4%
Drivers:	2 x 210 mm (2 x 8")
Weight:	30 kg (66 lb)
Dimensions: Height Width Depth	615 mm (24 1/6") 320 mm (12 1/2") 510 mm (20")

Amplifier

Short term amplifier output power:	180 W (4 Ohm)
Long term output power is limited by driver unit protection circuitry.
Amplifier system distortion at nominal output:	THD < 0.08% SMPTE-IM < 0.08% CCIF-IM < 0.08% DIM 100 < 0.08%
Signal to Noise ratio, referred to full output:	> 100 dB
Mains voltage:	100/200 or 115/230V
Voltage operating range:	± 10%
Power consumption (average): Idle Full output	50 VA 300 VA

Crossover

Subsonic filter (18 dB/octave) below:	33 Hz
Crossover frequency, (sub/main monitors)	85 Hz
Crossover acoustical slope Lowpass: Highpass:	28 dB/octave 12 dB/octave
Midband rejection, freq. > 400 Hz:	> 50 dB
Bass roll-off control operating range in 2 dB steps:	from 0 to -6 dB @ 33 Hz
Phase matching control in 90° steps:	from 0° to -270° @ 85 Hz

Input/Outputs

Input connectors: XLR female	pin 1 gnd pin 2 + pin 3 -
Input impedance:	10 kOhm balanced
Input level for 100 dB SPL output @ 1m:	variable from +6 to - 6 dBu

Output connectors: XLR male	pin 1 gnd pin 2 + pin 3 -
Output impedance:	100 Ohm balanced, active floating
Gain:	0 dB